Chevrolet 2009 Uplander Owner's Manual page 222

REMOTE START DISABLED
If your vehicle has the remote start feature, this
message displays if a remote start attempt is
unsuccessful. This may be caused if any of the following
conditions are true when a remote start attempt is made:
•
The remote start system is disabled through the DIC.
•
The key is in the ignition.
•
The hood or the doors are not closed.
•
There is an emission control system malfunction.
•
The engine coolant temperature is too high.
•
The oil pressure is low.
•
The hazard warning flashers are turned on.
•
The maximum number of remote starts or remote
start attempts between ignition cycles has been
reached.
•
The content theft-deterrent alarm is on while
attempting to remote start the vehicle.
See "REMOTE START" under DIC Vehicle
Personalization (Uplevel Only) on page 3-68 and
"Remote Vehicle Start" under Remote Keyless Entry
(RKE) System Operation on page 2-5 for more
information.
3-62
REMOTE START ON
If your vehicle has the remote start feature, this
message displays when a remote start is initiated.
See "Remote Vehicle Start" under Remote Keyless Entry
(RKE) System Operation on page 2-5 for more
information.
RIGHT FRONT TURN LAMP OUT
This message displays when the right front turn signal
bulb needs to be replaced. See Headlamps and
Sidemarker Lamps on page 5-42.
This message displays while the ignition is in ON/RUN.
Press any of the DIC buttons to acknowledge this
message and to clear it from the screen.
This message continues to display for two seconds if it
has not been acknowledged when the engine is turned
off. It also re-displays for two seconds if the message has
been acknowledged, but the condition still exists when
the engine is turned off.
If the condition still exists, the message re-appears
when the engine is turned on.