Advertisement
TUF-2000F User Manual
This function can used to produce an alarm or output when fluid material changes.
M+7
Displays total flow for this month(only for the time past)
M+8
Displays total flow for this year(only for the time past)
Display the not-working total time in seconds. The total failure timer will also include
M+9
the time when power off, if the back-up battery is applied.
M.2
Entry to solidify the zero point. Password protected.
Setup the Q value threshold.
If the present Q is below this threshold, flow rate will be set to 0.
M.5
This function is useful when flow meter is installed in noisy environment or on airy
pipes.
M.8
The maximum flow rates for today and this month.
M.9
Serial port tester with CMM command output for very second.
M-0
Entry to hardware adjusting windows only for the manufacturer
M-1
4-20mA output adjustment
M-2
4mA calibration for AI3 input
M-3
20mA calibration for AI3 input
M-4
4mA calibration for AI4 input
M-5
20mA calibration for AI4 input
M-6
4mA calibration for AI5 input
M-7
20mA calibration for AI5 input
M-8
Lower Temperature Zero setup for the PT100
M-9
Higher Temperature Zero setup for the PT100
M-A
Temperature Calibration at 50℃
M-B
Temperature Calibration at 84.5℃
Note 1.windows in
Red
2. Windows in
3. The term totalizer is also called accumulator.
4. Begin to mount and measure
4.1 Steps to Configure the Parameters
The following parameters need to be configured for a proper measurement:
(1) Pipe outer diameter
(2) Pipe wall thickness
(3) Pipe materials (for non-standard pipe materials*, the sound speed for the material must be configured
too)
*Standard pipe materials and standard liquids refer to those with the sound parameters that have
already been programmed into software of the flow meter, therefore there is no need to configure them
(4) Liner material and its sound speed and thickness, if there is any liner.
are new to our old version of flow meter
Blue
are energy related windows
14
Advertisement
