Running Hot Water - andrews WH42 Owner's Manual

When using RC-7508M

Running Hot Water

On this Display
1
2
Check
Previous set temperature
WARNING
Be especially careful if using hot water after previously using water at 60°C or above to prevent scalding.
WARNING
This is to prevent scalding if the temperature rises. Conversely, if the temperature drops or the
power switch is turned "off", the user may be upset when the water suddenly becomes much colder.
Press the
ON/OFF
button to turn it
"On".
Turn on hot water.
(Eg.: 40°C)
Whenever using the hot water, such as when using the shower,
check the temperature shown on the remote controller first, and
then test the hot water temperature by hand.
While the shower is being used, no one other than the user
should change the temperature, the power switch must not be
turned "off". (when using sub remote controller.)
Operation
* The
* This is lit during combustion.
Description
is lit.
ON/OFF
Here
(Display example)
11