Function Parameter Setting - Vertex Standard VZ-88 Operating Manual

Function parameter setting

User may set the following parameters by CPS:
● Squelch level
Scan Dwell Time
●
Channel Display Mode
●
● Key Lock Mode
● Key Tone
Auto Power Off
●
VOX Sensitivity
●
Opening Display Message
●
DTMF setting
DTMF side tone
●
Pre-Only Code
●
DTMF Speed
●
● First digit delay time
FM function setting
● Enable FM Function
FM working mode
●
Enable FM Function
●
25 channels Frequency list (87.0 – 108MHz)
●
Scan List
Available channels can be added into scan list, or
delete channel number from scan list.
Programmable side button
User can set side button 1, 2 (long press/short press)
as bellow functions:
30
TX time out timer
●
Reverse Burst
●
Back Light
●
Work Mode
●
Power Saver
●
Bank
●
VOX Delay Time
●
Password PIN
●
PTT ID
●
●
Post-Only Code
●
First digit time
DW (Dual Watch)
●
FM VFO Frequency
●
DW (Dual Watch)
●
● None
scan On/Off
●
High/Low Power
●
● Back Light On/Off
Monitor
When enabled, the monitor button will give out squelch.
It is to check if current channel have been occupied
and will temporarily get rid of the CTCSS/DCS,
meanwhile it will receive some week signals.
Scan On/Off
Scan on: Touch the programmed side button, it starts
from current channel. When a channel receives signal
and squelch type is matching, the green LED indicator
lights on and stays in current channel.
Scan off: Touch the side button again to quit scanning.
Nuisance Delete
Sometimes scanning will stay in a nuisance channel,
press "Nuisance delete" to delete the channel
temporarily from the scanning list, it won't be scanned
again in current operation. Enable scanning again and
it will be added to the list.
High/Low Power
Shift from high/low power mode by enabling the
programmable button as high/low.
Monitor
●
Nuisance Delete
●
Talk-around/Repeater
●