Vertex Standard VZ-88 Operating Manual page 24

the repeater function.
When at different TX/RX frequencies, the repeater can
be enabled. The icon " " is displayed as repeater is
enabled, and once pressing "F" + "4" keys, it will
change the repeater status. When the repeater stops it
is called "talk- around", at that moment the TX
frequency & PL/DPL becomes same as the RX
frequency & PL/DPL.
Press "F" + "5 " key: To set reverse burst.
REV
While talking, release "PTT" to stop transmitting, there
is a harsh "ZaZa" sound heard by the RX user. Set
STE on can remove this noise.
There are 4 STE modes to select: frequency, phase
deviation 120°, phase deviation 180°, phase deviation
240°.
Note: This is effective only when the opposite radio has
the same STE mode.
Press "F" + "6SQT" key: To enter squelch
technology setting.
Display received PL/DPL for: no code as "R OFF", PL
as "R 67.0" or DPL as "R 023N", reversed DPL as
"R023I".
Press "6 " key to shift from above 4 types of

SQT
squelch mode;
If it is PL, press "▲/▼" key to select from 50 groups

PL(refer to coding form)
If it is DPL normal code, press "▲/▼" key to select

from 104 groups N DPL.
If it is DPL reverse code, press "▲/▼" key to select

from 104 I DPL.
Press "F" key to confirm and enter PL/DPL TX

setting, but it'll quit if current channel is at
talk-around mode; press "PTT" button to confirm
and quit.
Display transmitting PL/DPL for: no code as "R OFF",
PL as "R 67.0" or DPL as "R 023N", reversed DPL as
"R023I".
Press "6 "key to shift from above 4 types of

SQT
squelch mode;
If it is PL, press "▲/▼" key to select from 50 groups

PL(refer to coding form)
If it is DPL normal code, press "▲/▼" key to select

from 104 groups N DPL.
If it is DPL reverse code, press "▲/▼" key to select

from 104 I DPL.
Press "F" key to confirm and quit, press "PTT"

button to confirm and quit.
Press "F" + "7 " key: To switch channel
MODE
display mode.
Enable it to switch channel display modes, display RX 23