Short Cut Keys - Vertex Standard VZ-88 Operating Manual

Short Cut Keys

Pressing "F" then a digit key can reach below short-cut
Key functions quickly:
"F" + "1" SQL
"F" + "2" PWR
"F" + "3" SCAN
"F" + "4" REP
"F" + "5" REV
"F" + "6" SQT
"F" + "7" MODE
"F" + "8" FM
"F" + "9" SEL
"F" + "0" LIST
Press "F" + "1SQL" key: To enter SQL level
setting menu.
Press "▲/▼" key to select SQL level from 0-9, press
"F" or "PTT" key to confirm and exit the setting mode,
press other key to go back to idle mode.
Press "F" + "2
TX power.
22
When TX power is high, it will display the "
Squelch level
TX power
Scan
Repeater
Reverse burst
Squelch technology
Channel display mode
FM radio enable/disable
Menu setting
Channel scan list adding
" Key: To switch high / low
PWR
save power, you may select low power TX.
Press "F" + "3
mode.
In FM VFO mode, the radio scans from FM frequency
87.0 to 108MHz, the scan stepping is 100 KHz. In FM
channel mode, saved FM channel frequency will be
scanned. If FM signal was detected, it will stop
scanning and stay in the active channel and listen.
Press "▲/▼"key to change scan direction or press any
other buttons to quit scanning.
In radio VFO mode, the unit scans in the frequency
range it supported, with selected frequency step
changing. In radio channel mode, the scan list
channels will be scanned. When channel bank is set,
only same bank channels are scanned.
When a channel/frequency signal is received and the
squelch is matching, it will stay in the channel and the
green LED will light up, press "PTT" to talk in that
channel. If you do not want to scan a channel, press
"Nuisance Delete" side button to skip the channel. The
channel won't be scanned again during current
operation.
In scanning, the icon "
change scan direction, press PTT button to TX on
current channel, press "F" + "3" key again to exit scan
mode.
" icon. To Press "F" + "4
" key: To enter scan
SCAN
" appears. Press "▲/▼" key to
" key: To enable or disable
REP