Canon ae1 Installation Procedures Manual page 24

3.1.2 Unpacking the Puncher Unit
MEMO:
The machine is fitted with tape and cushioning ma-
terial to protect against vibration and shock during
transit. Be sure to remove all of it as instructed be-
fore the installation work. It is a good idea to store
away the removed tape and cushioning material for
possible future relocation and shipment for repairs.
1) Remove the attachments and the puncher unit from
the shipping box.
2) Remove the tape from the outside of the puncher
unit.
3) Open the punch upper cover.
4) Remove the two fixing screws [ l ] each, and detach
the front and rear punch fixing plates [2].
3.1 . 3 Installation Procedure
1. Connecting the Finisher
<Finisher-AE 1 >
1) Remove the two screws [I], and detach the inlet
guide [2]; then, remove the four screws [3], and de-
tach the right cover [4].
<Saddle Finisher-AE2>
1) Remove the two screws [I], and detach the right
front cover [2]. (The front cover is not required any
longer.)
PI
F-1-60
2) Fit two stepped mounting screws [I] (M4 x 4) to the
pickup assembly of the finisher.