Canon ae1 Installation Procedures Manual page 33

Hide thumbs Also See for ae1:
Table of Contents

Advertisement

Making Checks after Adjustment
1) Check to see once again the that the difference in
height between the finisher and the puncher unit
and the tilt are as indicated; If not as indicated, start
over the adjustment work.
2) When done, tighten the two fixing screws [l] each
on the casters.
3) To prevent the adjusting bolts from becoming loose
during transit for possible relocation after installa-
tion, tighten the bolts [2] 90 deg in the direction of
the arrow. Take care, however; excess tightening
will affect the heighthilt.
4) Attach the spanners to the back of the front cover
using a screw.
5) End the installation work as instructed in "Installa-
tion after ChecksIAdjustments" and later.
3.2.2 Installation after Checks/
Adjustments
<Finisher-AE l >
1) If you have removed the auxiliary ring, mount the
rear left foot cover, and adjust the auxiliary rail to
suit the needs of the user, and
fur
it in place using
four screws.
2) Mount the front cover to the finisher using three
screws.
3) Mount the lower front extension cover [I] using a
screw [2] (RS tightening; M3 x 8). Mount the fiont
foot cover [3] using a screw [4] (RS tightening; M3
x 8).
4) Connect the finisher and the host machine using an
interface cable [I].

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ae2M2N1P1L1

Table of Contents