Canon ae1 Installation Procedures Manual page 23

3. I
Installation Procedure
3) Mount the fixing plates [I] and [2] that come with
the puncher unit at the front and the rear, respec-
(When Installing the Fin-
tively, using four screws [31 (binding; ~4 x
6).
isher and the Puncher Unit
at the Same Time)
3.1 . I
Making Preparing on the Host
Machine
Before connecting the finisherlpuncher unit to its
host machine, mount the fixing plate to the host ma-
chine.
1) Detach the blanking covers [ l ] and [2] from the left
cover using a nipper.
2) Detach the blanking cover [3] from the left rear
cover using a nipper.
A
When mounting the puncher unit, mount the fix-
ing plate that comes with the puncher unit and
then make the necessary connection.
If the fixing plate [ l ] cannot be attached because
the blanking part on the host machine's left cover
is small, remove the following parts:
Host machine's front cover (one blanking rub-
ber and two screws)
Host machine's left cover (four screws)
Next, attach the fixing plate [I] and then attach
the cover in place.
Use the fixing plates [l] and [2] that come with
puncher unit.
the