Coolant Connection For Automatic Transmission - Webasto THERMO TOP E Installation Instructions Manual

Coolant connection for automatic transmission

WARNING!
Tighten all hose clamps to 2.0 + 0.5 Nm.
Any cold water running off should be collected using an appropriate container!
Route coolant hoses kink-free! Unless specified otherwise, always fasten using cable ties.
Position hose and spring clips so that no other hose can be damaged!
The connection should be "inline" based on the following diagram:
B
All clamps without a specific designation are 20-27 mm dia. hose clamps.
All connecting pipe not specified are 20 mm x 20 mm dia.!
Nissan Pathfinder and Navara
D
Motor
C
Heat
exchanger
Original
clamp
A
Original
hose
Coolant
diagram
for auto-
matic
transmis-
sion
24