Connect Power; Power Cable Cautions - Honeywell Thor VM3 Manual

Connect Power

See Power Supply Connector
For the VM1D Standard Dock and VM3D Enhanced Dock, power options include:
• 12-48 VDC Vehicles (10-60 VDC Direct Connection)
• 60-144 VDC Vehicles (50-150 VDC Power Supply, Screws on Side of Lid)
power supply.
• 60-144 VDC Vehicles (50-150 VDC Power Supply, Screws on Top of Lid)
power supply.
• VX6 / VX7 Adapter Cable
• Thor VX8 / Thor VX9 Adapter Cable
VM3D Enhanced dock( replaces a previously installed Thor VX8 or Thor VX9.
• Screen Blanking (page 4-32) - Optional connection to blank the Thor VM3 display while the vehicle is in motion.
• External AC/DC Power Supply
an office environment.
For the VMX3D Enhanced Dock, power options include:
• VMXD Enhanced Dock with Thor VX8/Thor VX9 Power Cable
VMXD Enhanced Dock) replaces a previously installed Thor VX8 or Thor VX9.
• External AC/DC Power Supply
an office environment.

Power Cable Cautions

CAUTION - When routing the power cable:
• Route power cable away from the outside of the fork truck.
• Choose a mounting location so that the power cable does not extend outside the vehicle and that provides sufficient
clearance so that the power cable (especially the dock connector end) is not pressed against part of the vehicle.
• Use the proper Strain Relief Cable Clamps
• The power cable is less flexible in low temperature environments. Avoid sharp bends.
Regularly inspect power cable for damage, especially in low temperature environments. Contact
Assistance (page 10-1) for replacement cable options.
Power Cable Routing
(page 9-6) for connector pinout
(page 4-29) - For applications where the Thor VM3 replaces a previously installed VX6 or VX7.
(page 4-30) - For applications where the Thor VM3 (with a VM1D Standard Dock or
(page 4-38) - For use when DC power is not available to power the Thor VM3, such as in
(page 4-38) - For use when DC power is not available to power the Thor VM3, such as in
(page 4-16) to secure cable.
(page 4-18) - Direct connection to vehicle power.
(page 4-23) - Requires the use of a DC/DC
(page 4-26) - Requires the use of a DC/DC
(page 4-35) - For applications where a Thor VM3 (with a
Technical
4 - 17