Connect Canbus Cable; Install External Antenna - Honeywell Thor VM3 Manual

Connect CANbus Cable

The CANbus/Audio connector supports a headset adapter cable or a CANbus Y cable. The Thor VM3 does not support
connecting audio and CANbus simultaneously.
See CANbus / Audio Connector
1. Seat the D15 cable end connector firmly over the CANbus/Audio Connector on the Smart Dock.
2. Tighten the thumbscrews in a clockwise direction. Do not over tighten.
3. The CANbus Y cable has a 9 pin F SAE J1939 (Deutsch) and 9 pin M SAE J1939 (Deutsch) connector. Connect the
appropriate cable connector as needed.

Install External Antenna

The external antenna cannot be used by devices with an internal antenna.
1. Remove the rubber cap, if present, from the antenna connector before connecting an external antenna.
2. Place the antenna over the antenna connector. If only one antenna is used, be sure to connect it to the Wi-Fi Main
connector.
3. Push down and twist the antenna base clockwise until secure.
4. Repeat for second antenna, if used.
4 - 44
(page 9-11) for connector pinouts.