Outputs - GE Reason RT430 Technical Manual

GPS Grandmaster Clock
Figure 30: Section to configure signals applied to synchronism outputs
4.4.1

Outputs


Output, Signal, Polarity: allow individually configuring synchronism signal and its polarity of
synchronism outputs;

TTL 1/2: allows configuring the TTL-level electrical outputs 1 and 2. Each output has two terminals,
one screw, and other BNC. Both terminals can be used simultaneously although its configuration is
unique, so the same signal will be applied to both terminals;

OPTO 1/2: allows configuring the two TTL-Level optical outputs;

OC 1/2: allows configuring the two open collector outputs;

RS232: allows configuring the Out pine signal of the serial output.
For each electrical, optical, open collector or serial output, it is possible to configure the following signals:
o
OFF - Output without synchronism signal;
o
PPS -Output with 1 pulse-per-second;
56 RT430-TM-EN-5