Power Supply - GE Reason RT430 Technical Manual

E
F
G
H
2.7

Power Supply

The unit can be powered from DC or AC power within the limits specified in
supplies allowing redundancy to ensure operation even if one of the power supplies is interrupted.
All power connections should use insulated flameproof flexible cable (BWF type) with a 1.5 mm² cross
section, 70 °C thermal class, and 750V insulation voltage.
To reduce the risk of electrical shock, pre-insulated tubular pin terminals should be used on the ends of the
power connections.
The pin terminals should be completely inserted into the connector supplied with the unity so that no metallic
parts are exposed, according to the
A 1.5 mm² ground lead shall be connected to the terminal marked with the protective earth symbol for safety.
RT430-TM-EN-5
2 optical outputs for synchronism
RS232 and RS422/485 serial port
Communication ports via Ethernet network
GPS antenna input
Figure 6: Pre-insulated tubular pin terminals
.
Figure 7
Figure 7: Supply connector assembly
Chapter 1. There are two power
RT430
31