Simrad MX610 Operator And Installation Manual page 62

62 |
www.busse-yachtshop.de | info@busse-yachtshop.de
MX61xJB junction box software update procedure using the MX61x display
(USB method)
This programming feature is available in MX610/MX612 CDU with s/w version V1.0-42.226 or
newer. Program update of the junction box can be done through the display USB. For junc-
tion boxes with software version 1.28 or lower, make sure there is external 12 VDC supply to
the NMEA 2000 network (see diagram below).
1.
Copy the junction box software file (*.swup) to a USB memory stick.
2.
Restore the junction box to default using the below procedure:
a. Press the MENU key.
b. Scroll to Tools and Settings, press ENT.
c. Select Network, press ENT.
d. Scroll to NMEA 0183 over MXJB, press ENT.
e. Select Restore to Default, press ENT.
3.
Insert a USB memory stick loaded with the MXJB *.swup file.
Press the USB key.
4.
5. Scroll to "Memory Card - USB", press ENT.
6. Scroll to MXJB 1_0_01_20.swup file (or newer version), press ENT.
Select the Upgrade button, press ENT.
7.
8.
Put a check mark on the "SI80 Pilot controller [00xxxx#]" or "MXJB NMEA0183 gateway
[00xxxx#]" device in the list. The MX612JB has three of these, please put a check mark and
upgrade one at a time starting at the gateway or controller with S/N [003xxx].
9. Press the MENU key, then choose Start Upgrade, press ENT.
10.
Answer YES on the dialog box.
11.
After a few seconds the progress meter will indicate the status of download.
12.
Repeat the process for gateway number [002xxx#], then finish with the programming with
the board s/n [001xxx#].
13.
Remove the USB.
14.
Verify the software version under the Menu/Tools & Settings/Network/Device List.
Maintenance | MX610/MX612 Operator and Installation Manual