Table of Contents
Advertisement
Maintaining the printer
–
To remove the finisher, hold the finisher on both sides, and then lift the latches to unlock the finisher.
•
If the printer does not have a caster base but is configured with optional trays, then remove the trays.
Note: Slide the latch on the right side of the optional tray toward the front of the tray until it clicks into place.
•
Use the handholds located on both sides of the printer to lift it.
•
Make sure your fingers are not under the printer when you set it down.
•
Make sure there is adequate clearance around the printer.
•
Use only the power cord provided with this product or the manufacturer's authorized replacement.
212
Advertisement
Table of Contents
