Connecting Wires To Terminals - Kenwood DMX100 Instruction Manual

Installation
Ñ Connecting wires to terminals
USB device
[2]
Subwoofer Preout
Connector B
1 3 5 7
2 4 6 8
1 3 5 7
Connector A
2 4 6 8
Ñ Wiring harness connector function guide
Pin Color and function
A-4 Yellow
A-5 Blue/White
A-7 Red
A-8 Black
B-1/ B-2 Purple (+) / Purple/Black (–)
B-3/ B-4 Gray (+) / Gray/Black (–)
B-5/ B-6 White (+) / White/Black (–)
B-7/ Green (+) /
B-8 Green/Black
• Speaker Impedance: 4-8 Ω
!
CAUTION
Before you connect the commercially available ISO
connectors to the unit, check the following condition:
• Make sure that the pin assignment of the connector
matches with the KENWOOD unit.
• Take extra notice of the power wire.
• In case battery wire and ignition wire are not
corresponding then change them accordingly.
• In case the car does not have an ignition wire, use a
commercially available interface.
USB terminal (0.8 m)
[1]
5V = 1A
Cap
SUB
WOOFER
Cap
Fuse (15A)
ISO Connector
Battery
Power Control
Ignition (ACC)
Earth (Ground) Connection
Rear Right
Front Right
Front Left
(–) Rear Left
Light Green
(Parking sensor wire)
(Extension cable)
For best safety, be
sure to connect the
parking sensor.
Purple/White
(Reverse sensor wire)
Connect to vehicle's reverse lamp harness
when using the optional rear view camera.
Light Blue/Yellow
(Steering remote control wire)
To steering remote
To use the steering wheel remote control
feature, you need an exclusive remote
adapter (not supplied) matched to your car.
FM/AM antenna input
AV-IN audio input
(Left; White, Right; Red)
Rear Audio Preout
(Left; White, Right; Red)
Front Audio Preout
(Left; White, Right; Red)
Visual Output (Yellow)
Rear view camera input (Yellow)
AV-IN visual input (Yellow)
USB maximum power supply current : DC 5 V = 1 A
[1]
[2] Sold separately
Connect to the
vehicle's parking
brake detection
switch harness.
FM/AM antenna
English |
15