Mounting the Router onto a Pole
Step 8
Hand-tighten the bolts and the nut (do not overtighten).
Step 9
Adjust the top edge of the mounting bracket until it is horizontal and tighten the screws and the flange nut to
13 to 15 ft lbs (17.6 to 20.3 Nm).
Step 10 Position the two screws on either side of the router with the bolt holes on the mounting bracket (see the
following figure).
Note
Figure 18: Mounting the Router onto the Mounting Bracket on the Pole
1
M8 x 12 screws
2
M8 spring washers
3
Mounting bracket
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
38
The router should be positioned with the LEDs on the bottom to allow viewing from the ground.
4
Pole
5
Metal straps
—
Installing the Router
OL-29732-01