Carrier 50TC*D17 Series Installation Instructions Manual page 31

Local Access
6
BACview Handheld
6
The BACview is a keypad/display interface used to
connect to the RTU- - MP to access the control information,
read sensor values, and test the RTU, see Fig. 53. This is
an accessory interface that does not come with the MP
controller and can only be used at the unit. Connect the
6
BACview to the RTU- - MP's J12 local access port. There
are 2 password protected levels in the display (User and
Admin). The user password is defaulted to 0000 but can
be changed. The Admin password is 1111 and cannot be
changed. There is a 10 minute auto logout if a screen is
idle. See Form 48- - 50H- - T- - 2T, Appendix A for navigation
and screen content.
Virtual BACview
Virtual BACview is a freeware computer program that
functions as the BACview
interface (USB- - L) is required to connect a computer to
the RTU- - MP board. The link cable connects a USB port
to the J12 local access port. This program functions and
operates identical to the handheld.
NOTE:
configuration of RTU- - MP, operating sequences and
troubleshooting information. Refer to RTU- - MP 3rd Party
Integration Guide for details on configuration and
troubleshooting of connected networks. Have a copy of
these manuals available at unit start- - up.
6
Fig. 53 - - BACview Handheld Connections
31
6
Handheld. The USB Link
Refer to Form 48- - 50H- - T- - 2T for complete
C09477