Setting The Gemini Device Ip Address In Gemini Software - Gemini 720i Product Manual

Appendix C. Setting the Gemini Device IP Address
in Gemini Software
These instructions are applicable to any Gemini device.
For a Sonar or
Profiler
For a Hub
After starting the Gemini software and
connecting a Gemini device click the
Advanced tab at the upper left hand side of
the screen to show the advanced settings
screen, and expand the Device Network
Details area by clicking the + button next
to it.
Once the ID of the Gemini has been entered at the top of the screen, the details for the new
IP address can be entered. Three items need to be entered, the Device ID (to ensure that
the correct Gemini is being altered), the new IP Address and the new Subnet Mask.
Once these details have been entered, pressing the Send Device Details button will
start the process of changing the IP address. A dialog box will open, requesting confirmation
of the change.
Clicking the Yes button will program the new IP address details into the Gemini. The new
IP address followed by a reboot command will be sent. When the device reboots it will be
using the new IP address, and therefore will not show up on the status display. Once the IP
address of the computer has been changed back to its original settings the Gemini should
once again appear on the status display.
Document: 0685-SOM-00001, Issue: 11
Enter the ID into the Sonar box of the Advanced Configuration options
(upper right hand side of the screen).
Enter the ID into the Hub ID box on the Hub Setup tab.
Note
The Gemini device should be connected directly to the computer and any other
Gemini devices should be disconnected.
Note
If the Gemini is online then it will not be possible to alter the IP address details.
Make sure that the Gemini is offline before trying to change it.
72
Gemini Imaging Sonar
© Tritech International Ltd.