Function Descriptions - Whirlpool AMD 093 User Manual

FUNCTION DESCRIPTIONS

6th Sense mode
The air conditioner automatically selects Cooling,
Dry or Heating mode,depending on room
temperature and sets the target temperature.
Operation mode and temperature are determined
by indoor temperature.
Electric heating models
Indoor
temperature
21°C or below
21°C-23°C
23°C-26°C
Over 26°C
NOTE: Temperature, airflow and direction are
controlled automatically in 6th Sense mode.
However, a decrease or rise of up to 2 ℃ can be
set with the remote control if you still feel
uncomfortable.
1. Press 6th Sense button.
2. In Fan Only mode, press Fan to select High, Mid
or Low.
Jet mode
Used for fast cooling. The air conditioner
automatically sets the fan speed to High and the
temperature to 18ºC.
NOTE: 6th Sense mode button does not operate
when Jet function is selected.
1. Press Jet. The air conditioner automatically sets
the fan speed to High and the temperature to
18ºC.
2. To exit Jet mode press any button except Timer
On/Off and Swing button.
Fan Speed
1. Choose desired fan speed.
Downloaded from AC-Manual.com Manuals
Operation Target
mode temperature
HEATING 22°C
FAN ONLY
DRY
COOLING 26°C
2. Each time the "FAN" button is pressed, the fan
speed is changed in sequence:
Auto → High → Mid → Low
↑
• Auto-automatically controls fan speed depending
on current room temperature and temperature
control setting.
NOTE: Auto fan speed cannot be selected in Fan
Only mode.
• High - for maximum cooling
• Mid - for normal cooling
• Low - for minimum cooling
Temperature
• Press the up Adjust button to raise the
temperature. Press the up Adjust button once to
increase the set temperature by 1ºC, or press
twice to increase the set temperature by 2ºC.
• Press the down Adjust button to lower the
temperature. Press the down Adjust button to
decrease the set temperature by 1ºC, or press
twice to decrease the set temperature by 2ºC.
NOTES:
• In the Cooling or Heating mode, the
temperature can be set between 18ºC and
32ºC.
• In Fan Only mode, the temperature cannot be
set.
U Button
When you press this button,the remote control
transmits signal of the actual room temperature
around it to the unit every 10 minutes. Therefore
please keep the remote control in a location
25