To install the new processor:
Insert the processor into the socket, using the key on the processor.
1.
Engage the retention plate and the load lever
2.
Figure 37
Inserting the Processor
CAUTION: With the load lever and the retention plate disengaged, hold the processor by its edges
and align it over the empty processor socket. Make sure that you properly align the processor with
the orientation notch on the socket.
CAUTION: To prevent overheating or a possible system crash, use only a heat sink model specified
for the HP ProLiant DL160se G6 server.
To install the heat sink:
Properly align the heat sink spring-loaded screws to the system board mounting holes.
1.
Tighten the spring-loaded screws clockwise to secure the heat sink connection to the system
2.
board.
Removal and replacement procedures 60