Control Panel On Your Dehumidifier; Control Panel Features - Honeywell HDH-125 Owner's Manual

Control Panel on Your Dehumidifier

C O N T R O L P A N E L F E A T U R E S
POWER Button
1 2 3 4 5
Press this button to turn the dehumidifier on and off.
Continue Button
1 2 3 4 5
When the unit is operational, pressing the
In this setting, the unit will not stop running until tank is full, regardless of humidity level setting.
Humidity Set Control Buttons
2 3 4 5
Humidity ( + - ) Buttons: When the unit is operating, the humidity setting will go up or down by pressing
these buttons, the range of adjustment is from 35% RH to 80% RH.
Fan speed Buttons
3 4 5
Press this button, the Turbo indicator illuminates and fan speed is high.
the Normal indication lamp illuminates and the fan speed is low.
Display Window
4 5
This window shows the actual % humidity level in your room (+5% accuracy). To adjust the desired %
humidity level, press the humidity (+ - ) Buttons. This window will also display Error codes which is
shown below.
E1 - Humidity sensor error - Unplug the unit and plug it back in. If error repeats, call for service.
E2 - Temperature sensor error - Unplug the unit and plug it back in. If error repeats, call for service.
P1 - Unit is defrosting - Allow the unit time to automatically defrost. The error will clear after the unit
self defrosts.
P2 - Bucket is full - Empty the bucket and replace in the right position.
Continuous
Power on
operation on
indicator light
indicator light
(green)
(green)
1
2
3
4
5
Button will go into CONTINUOUS DEHUMIDIFYING mode.
Tank full indicator
light (red)
High fan
indicator light
(green)
Normal fan
indicator light
(green)
Press this button,
5