Related Manuals for Honeywell TP30WK
Summary of Contents for Honeywell TP30WK
- Page 1 Dehumidifier and Smart Dehumidifier User Manual Read and save these instructions before use Model: TP30WK / TP30WKN / TP30AWKN / TP50WK / TP50WKN / TP50AWKN / TP70WK / TP70WKN / TP70AWKN/ TP70PWK / TP70PWKN www.jmatek.com Email: info@jmatek.com...
- Page 2 Amazon Echo device, to control the unit. Set up the Honeywell Air Comfort App on your smart phone or tablet to connect the Honeywell Smart Dehumidifier for WiFi and Voice control (only available for Smart Dehumidifier models).
-
Page 3: Safety Rules
THANK YOU Thank you for purchasing a Honeywell Dehumidifier. This User Manual is intended to provide you with important information needed to set up, operate, maintain and troubleshoot this product. SAFETY RULES WARNING -- READ AND SAVE THESE INSTRUCTIONS BEFORE USING THIS PRODUCT. - Page 4 SAFETY RULES (CONTINUED) • DO NOT let children play with this appliance, packaging or included plastic bag. • If the unit is damaged or it malfunctions, do not continue to operate it. Unplug the product from the electrical outlet. Refer to the troubleshooting section and contact the customer support center.
-
Page 5: How A Dehumidifier Works
HOW A DEHUMIDIFIER WORKS When the dehumidifier is switched ON, a fan pulls moisture-laden air into the dehumidifier where it passes through dehumidifying coils inside the unit. These coils condense moisture from the air and collect it in the water tank. The dry air is then exhausted from the dehumidifier. The air flows through the air vents of the dehumidifier into the room as dry, warm air. - Page 6 SELECTING A LOCATION - IMPORTANT (CONTINUED) • Place the dehumidifier in an area where the temperature will not drop below 41°F (5°C) • Place the dehumidifier at least 17.7 inches (45 cm) away from other objects (e.g. curtains or furniture) that may restrict airflow from the back or through the air vents of the unit. •...
- Page 7 UNPACKAGING THE DEHUMIDIFIER • This Dehumidifier is packaged with a colored or transparent tape to secure some parts during transportation. Remove the colored or transparent packaging tape from the unit. Splash 1. Gently pull the water tank from out of the dehumidifier Guard 2.
-
Page 8: Parts Description
PARTS DESCRIPTION Control Panel 10) Dehumidified Air Exhaust Vent Handle 11) Washable Dust Filter LED Display Direct Drain Outlet Splash Guard Direct Drain Cap Water Tank Handle 14) Mounting Holes for Cord Winders Foam Float Power Cord & Plug Water Tank 16) Cord Winders Continuous Water Drain Tube Water Level Indicator... - Page 9 INSTALL THE CORD WINDER Once you have removed the cord winder accessories from the water tank - follow the steps below. Step 1: Line up the cord winder pieces to the mounting holes. Step 2: Rotate 45-degrees clock-wise. Step 3: Once you hear “click”, then you know the cord winder is ready for use. NOTE: Once the installation of the cord winder has been completed.
-
Page 10: Use And Operation
USE & OPERATION CONTROL PANEL (10^) (11*) Display Screen Filter Alert Power Control Sleep Mode Humidity / Timer Set Controls Water Full Indicator Light Fan Speed Control Continuous Operation Light Timer Control 10^) Wi-Fi Connectivity and Voice Activated Control ^ THIS IS ONLY FOR MODEL TP30AWKN / TP50AWKN / TP70AWKN WITH WIFI SMART FEATURES NOTE: For detailed instructions to set up your dehumidifier for connected operation from your smart phone or tablet, separate user... - Page 11 USE & OPERATION (CONTINUED) FUNCTION BUTTONS POWER CONTROL Press to switch the dehumidifier ON or OFF. HUMIDITY CONTROL SETTING When the unit is switched ON, the Display Screen shows the current humidity percentage. Press to select your preferred humidity level. The humidity is adjusted in increments of 5% by pressing .
- Page 12 USE & OPERATION (CONTINUED) FUNCTION BUTTONS (CONTINUED) WATER TANK FULL ALERT When the Water Tank is full, the indicator will be illuminated. The unit will beep for 3 seconds. The compressor will shut off, and the fan will stop for a few minutes. To switch off the indicator light, empty the water tank and when replacing it ensure the tank is secured properly in place.
- Page 13 USE & OPERATION (CONTINUED) FUNCTION BUTTONS (CONTINUED) FILTER ALERT When the Filter Alert Light is ON, it is time to clean the filter. Switch the unit OFF and carefully remove the filter from the unit and clean. Replace the filter, switch on the unit and reactivate the Filter Alert button by pressing it once.
- Page 14 USE & OPERATION (CONTINUED) DRAINING THE WATER WARNING: Always drain and discard water collected from dehumidification. The water is not clean and cannot be used for drinking. 1. Draining water collected in the Water Tank The condensed water can be collected directly into the water tank. When the water tank is full, the dehumidifier will automatically shut OFF and the indicator will illuminate on the control panel followed by a beeping sound.
- Page 15 USE & OPERATION (CONTINUED) DRAINING THE WATER (CONTINUED) 2. Continuous Water Drainage – Using a Continuous Water Drain Tube A continuous water drain tube is included with this unit. To activate the continuous water draining function, you will require a suitable water drain (e.g. sink or drain hole at floor level) near the dehumidifier.
- Page 16 USE & OPERATION (CONTINUED) DRAINING THE WATER (CONTINUED) If there are leaks, the Continuous Water Drain Tube and Cap may have loosened and may not be connected properly. Disconnect, replace and tighten again. Position the other end of the Continuous Water Drain Tube in the sink or drain.
- Page 17 USE & OPERATION (CONTINUED) DRAINING THE WATER (CONTINUED) 3. Continuous Water Drainage – Using the Auto Drain Pump option *THIS IS ONLY FOR MODEL TP70PWK / TP70PWKN WITH BUILT-IN DRAIN PUMP The Auto Drain Pump is available if you want to use the continuous drain function, but the drain is further away, or located above the dehumidifier.
- Page 18 USE & OPERATION (CONTINUED) DRAINING THE WATER (CONTINUED) If there are leaks, the Auto Drain Pump Tube and Auto Drain Pump Cap may have loosened and may not be connected properly. Disconnect, replace and tighten again. To activate the Pump function, press the indicator.
- Page 19 USE & OPERATION (CONTINUED) CLEANING & MAINTENANCE WARNING: Always switch OFF the dehumidifier and unplug it from the electrical outlet before attempting any cleaning or maintenance of this product. Appliance Maintenance: • Switch OFF the appliance before disconnecting the power supply. •...
-
Page 20: Troubleshooting Guide
TROUBLESHOOTING GUIDE The following troubleshooting guide addresses the most common problems. If problems persist, call customer service. PROBLEM POSSIBLE CAUSE SOLUTION No electricity. Check for power. The power cord is not Remove and reconnect the power cord. Dehumidifier properly plugged in. does not start The water tank is not in Position the water tank correctly into the unit. - Page 21 TROUBLESHOOTING GUIDE (CONTINUED) PROBLEM POSSIBLE CAUSE SOLUTION Unit runs but Insufficient time for the the humidity After initial installation, allow 24 hours to maintain dehumidifier to remove level does desired dryness. moisture. not decrease The capacity of your dehumidifier may not be Area to be dehumidified adequate for the room it is used in.
- Page 22 TROUBLESHOOTING GUIDE (CONTINUED) PROBLEM POSSIBLE CAUSE SOLUTION Check the connections between the hose and the The garden hose/ drain drain outlet on the unit. See Continuous Water hose may be loose. Drainage section. Water on the floor You intended to use the Disconnect the hose and replace the rubber stopper water tank to collect water and drain cap if using the water tank to collect water.
-
Page 23: Error Code Guide
ERROR CODE GUIDE CODE POSSIBLE CAUSE POSSIBLE SOLUTIONS This only appears for model TP70PWK / TP70PWKN Water tank not installed with Built-in Drain Pump. Position the water tank or positioned correctly correctly into the unit. Unit will not operate until the water tank is secured in the correct position. - Page 24 REGULATION STATEMENT FCC INTERFERENCE STATEMENT This device complies with part 15 of the FCC Rules. Operation is subject to following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- Page 25 Made in China © 2021 JMATEK Limited. All rights reserved. The Honeywell Trademark is used under license JMATEK North America LLC from Honeywell International Inc. Honeywell International Inc. makes no Mahwah, New Jersey 07495 USA representations or warranties with respect to this product.