Battery Storage - Cushman HAULER PRO X Owner's Manual

3. If the batteries have been cleaned and the acid in the battery rack area is neutralized as recommended, no cor-
rosion to the battery racks or surrounding area should be present. If any corrosion remains, remove it with a putty
knife and a wire brush. Wash the area with a sodium bicarbonate (baking soda) and water solution, and then dry
before primer and corrosion resistant paint is applied.
4. Put the batteries in the battery racks and tighten the hold downs to 45 - 55 in. lbs. (5 - 6 Nm) torque. The hold
downs must be tight enough to prevent movement of the battery, but not tight enough to cause distortion of the
battery cases.
5. Inspect all wires and terminals. Clean corrosion from the battery terminals or the wire terminals with a sodium
bicarbonate (baking soda) and water solution and soft brush if needed.
Be careful when using aerosol containers near battery terminals. Always use a container
with insulation to prevent an explosion.
6. Connect the battery wires as shown.
7. Tighten the battery post hardware to 90 - 100 in. lbs.
(6 -8 Nm) torque. Do not over-tighten the terminal
stud nut, this will cause a "mushroom" effect on the
battery post which will prevent the terminal nut from
being correctly tightened.
8. Protect the battery terminals and battery wire termi-
nals with a commercially available coating.

BATTERY STORAGE

NOTICE: Disconnect the battery charger, controller and other electronic devices for extended storage. All
connected electronic components cause the discharge of batteries.
Put the run/tow switch in the TOW position for extended storage of the vehicle to prevent draining
of the batteries.
During storage, the batteries must not be allowed to discharge.
WHT from
Charger
From Battery
Temp Sensor
WHT from
Receptacle
BLU from
Receptacle
To Charger
M
AINTENANCE
Front of Vehicle
51