Environmental Awareness; Charger; On Board Charger - Cushman HAULER PRO X Owner's Manual

O
PERATION

ENVIRONMENTAL AWARENESS

When driving the vehicle, be careful of potential environmental hazards like steep
slopes, rocks, tree branches, etc. that could cause an incident that could result in vehicle
damage, personal injury or death.
There is a risk of fire when the vehicle is operated near combustible material.
Always be respectful of the environment.
Respect all wildlife and their habitat.
Respect private property and comply with all local laws and regulations governing the use of light duty utility vehicles.
Make sure you are permitted by property owners to operate the vehicle on their property.
If operating your vehicle on private property, obtain permission from the owner prior to entering their property.

CHARGER

Both off board and on board chargers should be operated in accordance with the charger manufacturer's instructions.
An on board charger is standard equipment on this vehicle. If the off board charger option has been selected, be sure
to retain and follow the operation instructions supplied with the charger. Always place the off board charger outside the
vehicle before and during the charging cycle. Never charge batteries in a hazardous environment.
Risk of electric shock. Connect the charger power cord to an outlet that is correctly
installed and connected to an electrical ground according to all codes and regulations. A
grounded outlet is necessary to decrease the risk of electric shock – do not use ground
adapters or replace the plug. Do not touch parts of output connector or battery terminals that do not have
insulation.
Disconnect the DC plug before you make or break the connections to a battery that is
charging. Do not open or disassemble the charger. Do not operate the charger if the AC
cord is damaged. Make sure qualified personnel does all repair work to the charger.
Refer to APPENDIX A for the charger manufacturer User's Guide for operating instructions, maintenance instructions
and troubleshooting instructions.

On Board Charger

To prevent over-heating that can cause damage to the charger and possible fire, keep the
air fins clear. Install portable chargers on a platform above the ground to allow maximum
air flow around and below the charger.
The power AC cord has a plug with a ground post. Do not remove, cut or bend the
ground post.
The on board charger is located under the driver side load bed. It is wired directly to the batteries. Before charging the
batteries, park the vehicle in a well ventilated area, engage the parking brake, turn key switch to OFF and remove key.
Plug charger cord into a dedicated 15 amp AC outlet to activate the charger. When the charging cycle is complete,
unplug the charging cord.
24