Wheel Installation; Lights; Halogen Headlight Bulb Replacement; Led Headlight Assembly Replacement - Cushman HAULER PRO X Owner's Manual

Wheel Installation

Lug Nut Torque
NOTICE: To decrease the risk of component damage, do not tighten the lug nuts
to more than the specified torque.
Always install lug nuts using a cross sequence pattern to ensure even
seating of the wheel against the hub.
1. Install the wheel on the hub with lug nuts. Make sure the valve stem is to the out-
side.
2. Finger tighten the lug nuts.
3. Using the tightening pattern shown at right, tighten the lug nuts to 65 - 85 ft.lbs. (88
- 115 Nm). Tighten in increments of 20 ft. lbs. (27 Nm).

LIGHTS

• Clean the lights frequently to maximize visibility.
• Replace burned out bulbs promptly.
Do not operate this vehicle at night or in low light if any bulbs are burned out. Poor light-
ing reduces visibility that could cause an accident resulting in severe injury or death.
NOTICE: Replacement bulbs are available from a local distributor, an authorized branch or the service parts
department.

Halogen Headlight Bulb Replacement

Light components can get hot if they have been in operation. Allow the lights to cool
before servicing to prevent burns to the skin.
NOTICE: Do not touch a halogen bulb with bare fingers.
Oil from skin leaves a reside that causes a hot
spot and will diminish the life of the bulb.
1. Disconnect the headlight harness from the headlight.
2. Rotate the bulb 1/4-turn to remove the headlight from the
housing.
3. Insert and rotate the new bulb to lock into place.
4. Connect the harness to the bulb.

LED Headlight Assembly Replacement

1. Disconnect the headlight harness from the headlight.
2. Remove the screws securing the headlight assembly to
the headlight bezel.
3. Remove the headlight assembly and install the new one
with screws.
4. Connect the harness to the headlight assembly.

Taillight

1. Roll the rubber bezel from around the edge of the taillight and remove the
lens.
2. Install the new bulb.
3. Replace the lens.
65 - 85 ft.lbs. (88 - 115 Nm)
M
AINTENANCE
Lug Nut Tightening Pattern
Screw
Headlight Housing
or
LED Headlight Assembly
Roll rubber bezel
away from body.
Inside of Cowl
Taillight
Brake Light
45