High Pedal Disable Feature; Diagnostic Mode Feature; Starting And Stopping The Vehicle; Starting On A Hill - Cushman HAULER PRO X Owner's Manual

O
PERATION
the Anti-Stall feature senses a stalled motor condition and removes power from the motor. When the brake pedal is
released, the vehicle will move backward slightly before power is returned to the motor.

High Pedal Disable Feature

High Pedal Disable prevents acceleration of the vehicle if the direction selector is changed or the key is turned on
while the accelerator is pressed.

Diagnostic Mode Feature

Diagnostic mode helps with troubleshooting.
With some electrical system failures, the Diagnostic Mode feature defaults to a mode that allows the vehicle to oper-
ate at a decreased speed.
This feature allows you to return the vehicle to the storage facility and identify the problem.
The technician can put the controller in diagnostic mode and the controller identifies the failure mode.

STARTING AND STOPPING THE VEHICLE

Unintentional roll-back of the vehicle could cause severe personal injury or vehicle dam-
age. To reduce the possibility of vehicle roll-back, keep the brake fully pressed until the
motor has started.
All vehicles have an interlock system that disables the controller and prevents operation or tow of the vehicle while the
charger is connected. Remove the charger plug from the receptacle and correctly store the cable before you move the
vehicle.
1. Sit in the driver's seat.
2. Press and hold the brake pedal.
3. Insert the key and turn to the ON position.
4. Move the direction selector to the appropriate position.
NOTICE: When the direction selector is moved to the reverse position, a warning alarm will activate to indi-
cate that the vehicle is ready to run in reverse.
5. Slowly press the accelerator pedal to start the motor.
6. When the accelerator pedal is released, the motor decreases the speed of the vehicle. To stop the vehicle more
quickly, press the brake pedal.
7. Engage the parking brake and remove the key from the switch before exiting the vehicle.

Starting on a Hill

Unintentional roll-back of the vehicle could cause severe personal injury or vehicle dam-
age. To reduce the possibility of vehicle roll-back, keep the brake fully pressed until the
motor has started.
Do not use the accelerator and motor to hold the vehicle on a hill. Doing so for more than
3 - 4 seconds will cause permanent damage to motor.
To decrease the risk of permanent damage to the drive system, do not allow roll-back
when you start the vehicle on a hill.
1. Press the brake pedal with your left foot when releasing the parking brake. Keep pressure on the pedal to pre-
vent the vehicle from rolling back.
2. Press the accelerator pedal with your right foot as you release the brake pedal.
3. Press the accelerator pedal with gradual and steady pressure until the vehicle reaches the desired speed.

ACCELERATING

Accidental movement of the accelerator pedal can cause the vehicle to suddenly move
and cause severe injury or death.
Make sure the key is in the OFF position and the parking brake is engaged any time the
vehicle is parked.
1. Release the parking brake.
2. Move the key switch to the ON position.
26