Use The Prosafe Plus Utility To Assign A Pvid To Ports - NETGEAR ProSAFE GS105Ev2 User Manual

WARNING:
Do not remove all ports from PVID 1, which is the management PVID.
If you remove all ports from PVID 1, you cannot access the switch for
management. In such a situation, to recover access to the switch,
you must reset the switch to its factory defaults settings.
9. Click the Apply button.
Your settings are saved.

Use the ProSAFE Plus Utility to Assign a PVID to Ports


To assign a PVID to one or more ports:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired network connection, or connect directly to a switch that is
off-network using an Ethernet cable.
2. Double-click the ProSAFE Plus Utility icon.
The Switch Selection page displays a list of Web Managed (Plus) switches that it
discovers on the local network.
3. Select the switch.
If you do not see the switch, click the REFRESH button.
4. Click the APPLY button.
You are asked to enter the password for the switch.
5. Enter the switch's password in the password field.
The switch's default password is password.
The Switch Status page displays.
6. Select VLAN > 802.1Q > Advanced > PVID.
You can select Port PVID only if you already enabled the advanced 802.1Q VLAN option
(see Create 802.1Q-Based VLANs in an Advanced Configuration
ProSAFE Gigabit Web Managed (Plus) Switches
Use VLANS for Traffic Segmentation
53
on page 46).