TES E- SD Operator's Manual page 8

• This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Use handles when
moving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and
curtains at least 3 feet (0.9 m) from the front of the heater and keep them away from the sides and rear.
• Do not operate this heater unless all panels and guards are in place and properly secured.
• Extreme caution is necessary when any heater is used by or near children or invalids and whenever the
heater is left operating and unattended.
• Always unplug the heater when not in use. To unplug the heater, turn E-TES SD switch to off, then
remove plugs from outlets.
• Unplug machine power cords from outlets & then disconnect cords from the E-TES SD before performing
any repair on the heater.
• This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate
heater where it may fall into a bathtub or other water container.
• Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an
electric shock or fire, or damage the heater.
• To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces,
like a bed, where openings may become blocked.
• A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or
flammable liquids are used or stored.
•
cool heater before turning air mover OFF. If air flow is turned off and the unit is not cooled properly the
heater box and front grill may get very hot, creating a burn hazard or damaging the unit.
• Restriction of the air flow from the heater snout may cause E-TES SD to overheat and shutoff.
• Adequate air flow must be maintained across heating elements for proper, safe operation. Do not disable
airflow sensor or other safety switches, doing so may result in damage to heater and will void warranty.
• Do not direct the outlet air flow towards objects which may be damaged by heat.
• Remove Feet or carpet clamps from snout of air mover before placing air mover into E-TES SD Electric
Thermal Exchanger to prevent damage to air seal gasket.
•
Controllers or other form of temperature control to keep room temperature below 105ºF
during the drying process.
AX33
12/3 X 50' Extension Cord
NEMA 5-15P & 5-15R ends
© Copyright Tes Drying Systems, 2014
Always turn Heater OFF and keep air mover running for 5 minutes to
Always use Remote Temperature Sensors, Remote Power
NM4407A
12/3 X 50' GFCI Protected Extension Cord – Auto Re-set
NEMA 5-15P & 5-15R ends
8