TES E- SD Operator's Manual page 12

Moisture 1 Value Screen: This tells you the current reading of the Moisture probe if it is
connected to the E-TES SD or the default value of 00% if the probe is not connected.
• Press DOWN to move to Moisture 2 Value Screen
• Press UP to return to Surface Temp Screen
Moisture 2 Value Screen: This tells you the current reading of the Moisture probe if it is
connected to the E-TES SD or the default value of 00% if the probe is not connected.
• Press UP to return to Moisture 1 Value Screen
• Press DOWN to move to Humidity / Internal Temperature
Screen
Humidity / Internal Temperature Screen: This tells you the relative humidity percentage
and temperature inside the E-TES SD box.
Remote Setup Screen: This allows you to set temperature at which the E-TES SD will turn
on Remote Exhaust Controller. (Remote Air Temperature Sensor to operate remote control.)
• Press DOWN to move to Air Flow Setup Screen
• Press UP to return to Humidity Internal Temperature Screen
© Copyright Tes Drying Systems, 2014
Press SELECT to set Moisture Probe shutdown
percentage. Use UP/DOWN to change moisture
percentage level set point.
UNIT WILL NOT SHUTOFF IF SET BELOW 10%
Press SELECT to set Moisture Probe shutdown
percentage. Use UP/DOWN to change moisture
percentage level set point.
UNIT WILL NOT SHUTOFF IF SET BELOW 10%
• Press DOWN to move to Remote Setup screen
• Press UP to return to Moisture 2 Value screen
Press SELECT to set the E-TES Remote Exhaust
Controller turn on temperature. Use UP/DOWN to
change temperature.
12