TES E- SD Operator's Manual page 27

11) Observe unit operation to be sure that air flow is kept at a high enough flow rate to prevent the heater from
turning ON and OFF. Remove restrictions to increase air flow as needed to maintain proper air flow rate.
12) Make sure circuit breakers are not tripping and the power supply to the air mover and E-TES SD unit will not
be interrupted.
13) When the E-TES SD unit is adjusted properly and operating normally, the unit can be left alone during
operation.
HEATER SHUTDOWN PROCEDURE
1) Turn the heater switch to the OFF position.
2) Keep the air mover running for 5 minutes to cool the heating elements.
3) When the unit has cooled turn the air mover OFF.
4) If required, insert USB Flash Drive into the USB port on the E-TES SD front panel, turn switch ON to log
data from job. When Flash Drive stops flashing, turn switch off, remove the Flash Drive and proceed with
shutdown. (Display will freeze on Updating USB - Do Not Remove screen while data is downloading.)
E-TES SD Charter software is required to view and chart job data log
information downloaded from the E-TES SD.
(See instructions on page 20)
5) Disconnect the power cords from the power outlets and heater connections. Roll up and store cords.
6) Remove and store air movers and E-TES SD Electric Thermal Exchanger.
© Copyright Tes Drying Systems, 2014
Flash Drive inserted into USB port to download job data.
27