TES E- SD Operator's Manual page 32

When the green HEATING light is OFF, but neither of the
red lights is ON, it usually means that one on the remote
sensors is getting a reading past its set point.
When the AIR TEMPERATURE, SURFACE
TEMPERATURE or MOISTURE VALUE measured by the
corresponding probe exceeds the set point the green
HEATING light will turn OFF indicating unit has shutoff the
power to the heating elements.
The screen for the sensor sending the shutdown reading will
be displayed, flashing the current reading and the shutoff set
point.
When the temperature cools sufficiently or the moisture level
rises the green HEATING light will turn back ON and the
unit will again heat up.
The power supply to the E-TES SD unit has been cut off.
Check the building circuit breakers and the GFCI cords
and reset as needed. There also could be a malfunction in
the heater switch or other internal wiring. Contact your
nearest service center for assistance.
ALL OTHER LIGHT COMBINATIONS WILL ONLY OCCUR WHEN THERE IS A
MALFUNCTION IN THE SYSTEM. IF YOU HAVE A LIGHT COMBINATION NOT SHOWN
AND DESCRIBED HERE, CONTACT YOUR NEAREST SERVICE CENTER FOR ADVICE OR
ASSISTANCE.
© Copyright Tes Drying Systems, 2014
POWER
HEATING
AIR FLOW
OVERTEMP
POWER
HEATING
AIR FLOW
OVERTEMP
32