TES E- SD Operator's Manual page 16

MOISTURE 1 VALUE SHUTOFF
When the MOISTURE 1 VALUE measured by the probe drops
below the set point the green HEATING light will turn off
indicating unit has shutoff the power to the heating elements.
The MOISTURE 1 VALUE screen will be displayed, flashing the
current moisture percentage and the shutoff moisture value
percentage set point.
If the moisture level rises sufficiently the green HEATING light will
turn back on and the unit will again heat up.
The MOISTURE 1 VALUE SHUTOFF will not shutoff the power
to the heating elements if the MOISTURE 1 probe is not connected.
If the E-TES SD is ON when the Moisture 1 Probe is connected,
the MOISTURE 1 VALUE SHUTOFF will shutoff the power to
the heating elements even if the MOISTURE 1 VALUE is above the
set point. The power switch must be turned OFF & back ON to
reset E-TES to read the correct the moisture value and allow power
to the heating elements.
Do not plug-in or unplug the Moisture Probes while the E-TES SD
is ON. Turn E-TES OFF before plugging in or un-plugging
Moisture Probes, then turn unit back ON.
MOISTURE 2 VALUE SHUTOFF
When the MOISTURE 2 VALUE measured by the probe drops
below the set point the green HEATING light will turn off
indicating unit has shutoff the power to the heating elements.
The MOISTURE 2 VALUE screen will be displayed, flashing the
current moisture percentage and the shutoff moisture value
percentage set point.
If the moisture level rises sufficiently the green HEATING light will
turn back on and the unit will again heat up.
The MOISTURE 2 VALUE SHUTOFF will not shutoff the power
to the heating elements if the MOISTURE 2 probe is not connected.
If the E-TES SD is ON when the Moisture 2 Probe is connected,
the MOISTURE 2 VALUE SHUTOFF will shutoff the power to
the heating elements even if the MOISTURE 2 VALUE is above the
set point. The power switch must be turned OFF & back ON to
reset E-TES SD to read the correct the moisture value and allow
power to the heating elements.
Do not plug-in or unplug the Moisture Probes while the E-TES SD
is ON. Turn E-TES OFF before plugging in or un-plugging
Moisture Probes, then turn unit back ON.
© Copyright Tes Drying Systems, 2014
Current Moisture
Level
To assure that the E-TES SD will
shut off & stay off when the
Moisture 1 Value drops below the
shutoff value, the Moisture Value 1
Shutoff MUST NOT be set below
To chart the Moisture 1 Value
without controlling the E-TES SD
set the Moisture Value 1 Shutoff to
Current Moisture
Level
To assure that the E-TES SD will
shut off & stay off when the
Moisture 2 Value drops below the
shutoff value, the Moisture Value 2
Shutoff MUST NOT be set below
To chart the Moisture 2 Value
without controlling the E-TES SD
set the Moisture Value 2 Shutoff to
16
Moisture Value
Set Point
10%.
0%.
Moisture Value
Set Point
10%.
0%.