4: Erasing A User Message; 5: Voice Loader Software - Honeywell ECC-50/100 Instruction Manual

Recording Custom Messages
Enter programming mode again and deselect Message Record Mode.
Press zone button 5
to select message
slot 5
3.5.4 Erasing a User Message
Messages stored in message slots 1-14 can be erased.
1. Enter programming mode at the main control board.
2. Enable Recording Mode in the system's message recording programming section. Refer to
Section 3.5.1 on page 71. The display board will then light the green zone 1-14 LEDs for all
message slots that contain messages.
3. Press zone button 24 on the display board, then zone button 1-14 for the slot to be erased. The
associated green zone LED will stay lit until complete.
4. Enter programming mode and deselect Message Record Mode.
3.5.5 Voice Loader Software
The Voice Loader (VL) software is used to download recorded messages (in .ske format stored on a
computer's hard drive) to the various message slots of the ECC-50/100. Messages can be uploaded,
stored, and used again in similar installations.
Make sure the system is in Normal Standby mode.
To write a message to the panel follow steps 1 through 5. To read a message from the panel follow
steps 1 through 4. To move a message from one message slot location to another, follow the combi-
nation of steps.
Emergency Command Center Manual — P/N LS10001-000FL-E:G 5/3/2016
Figure 3.1 Microphone Recording Example
Programming
Press zone button
17 to record
75