3: Address Assignment; Remote Microphone / Operator Console Address Assignments - Honeywell ECC-50/100 Instruction Manual

Emergency command center, multipurpose emergency voice evacuation panels
Table of Contents

Advertisement

Programming
Device Control Timeout Enter the maximum amount of time (30-300 seconds) that one of the
devices (Primary Operator Console, Local Operator Console, Remote Page Unit, or Remote Micro-
phone) can remain in manual control of the ECC system.
Paging Timeout Enter the maximum amount of time (30-300 seconds) that the microphone's
PTT switch can be held.
3.2.3 Address Assignment

Remote Microphone / Operator Console Address Assignments

Any combination of up to eight (8) remote consoles (ECC-LOC, ECC-RPU, and ECC-RM) can be
used in the system. Odd numbered addresses are not selectable. Addresses must be sequential, even
numbers. Identify which consoles are installed at addresses 4, 6, 8, 10, 12, 14, 16, and 18 as either
Local Operator Console or Remote Microphone. Note that the ECC-RPU and ECC-RM are both
considered remote microphones. Refer to Section 2.14, "Addressing External Data Bus Devices"
for information on dipswitch settings.
Mic Gain is the microphone's transmitting "volume control". The gain number is automatically
entered when a remote console is programmed.
64
Figure 3.6 RM/Console Address Assignments
Emergency Command Center Manual — P/N LS10001-000FL-E:G 5/3/2016
Main Menu - User Programming

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ecc-50/100e

Table of Contents