2: Usb File Options; Main Menu - Informational - Honeywell ECC-50/100 Instruction Manual

Main Menu - Informational

3.3.2 USB File Options
The ECC system allows software files to be saved, shared, and transferred via the computer's USB
port. The program file must be named CONFIG.TXT. When saving the program file to USB, it is
vital that no other files with the same name exist on the drive. The existing file will be completely
overwritten. Only files named CONFIG.TXT can be recalled from a USB drive. The ECC system
will verify that the file is compatible.
After a Save or Recall has been performed, the screen will show "Processing USB Request". Once
this is complete, the screen will show either a success message in green or a failure message in red.
If a failure message appears, correct the issue and try again.
3.4 Main Menu - Informational
From the main screen, programmed information for the 24 possible speaker circuits can be viewed
without accidentally making changes. Viewing this information does not require login to the sys-
tem.
Emergency Command Center Manual — P/N LS10001-000FL-E:G 5/3/2016
Figure 3.11 Main Menu
Programming
69