Table of Contents
Advertisement
Q (Question)
The clock is not set
correctly.
The retouch
software does not
start even if retouch
files (extension
".ped") are clicked
on Windows
Explorer etc.
When this unit is
connected to the
PC, the Card
Access Lamp
keeps blinking.
[Found New
Hardware Wizard]
appears though this
unit is connected to
the PC after the
USB driver is
properly installed.
If you do not use this unit for a long period of time,
the clock may be reset. When the screen of clock
setting appears, set the clock again.
If you record pictures without the clock setting, the
date is recorded as [1/1/2000 0:00].
If both SD Viewer supplied with this unit and
SD Viewer Ver. 2.1E supplied with SD Multi Camera
SV-AS10 are installed in the PC and uninstall either
of them, the association of retouch files with
SD Viewer will be disabled. In this case, uninstall
both versions of SD Viewer and then install the one
you want to use again.
Did you insert an NTFS-formatted Memory Card
into this unit? In this case, log on with [Administrator
(computer administrator)] (or any other user name
having equivalent rights), right-click the Removable
Disk icon in [My Computer], and select [Remove].
Check that the Card Access Lamp is lit and then
cancel the connection between this unit and the PC.
1 Click [Next].
2 Confirm whether your device is configured to the
optimal driver detection setting and click [Next].
3 Insert the supplied CD-ROM into the CD-ROM
drive.
4 Enter the path as "D:\USB Driver\files" (example
of D drive assigned as CD-ROM drive).
5 Click [Next].
6 Click [Next].
7 Click [Finish].
After the procedure above, follow the wizard to
install the hardware.
A (Answer)
99
VQT0Q47
Advertisement
Table of Contents
