Panasonic D-Snap SV-AS3 Operating Instructions Manual page 73

3
4
≥ Do not disconnect the USB cable or the AC adaptor from this unit, or
do not remove the card while the Card Access Lamp on this unit is
blinking. The software may not be properly operated or the data
being transferred may be damaged.
≥ Do not use any other USB cables except the supplied one.
≥ Do not disconnect the AC adaptor while connecting to the PC.
≥ When the PC connection mode on this unit (displayed as
[ACCESSING PC]) is not cancelled even if you turn the PC off,
disconnect the USB cable.
≥ If the PC is in the power saving mode while connecting to this unit,
the PC may not recognise this unit when recovering from the power
saving mode. In this case, restart the PC after you disconnect this
unit. (When you connect this unit to the PC and use it for a long time,
cancel the setting in the power saving mode beforehand.)
1
2
Connect this unit to the
power plug with the AC
adaptor 1 and the AC
mains lead.
Connect this unit to the PC
with the supplied USB cable
2.
– [ACCESSING PC] indication
appears.
• If the [ACCESSING PICTBRIDGE/
PTP] indication is displayed, once
disconnect the USB cable and
then confirm the setting in Step 2.
73
VQT0Q47