Glacial 8LCH-KK-SC-SSF-40 User Manual page 23

Your Brewer has two capsule piercing needles. One on top, called inlet needle and one at the
bottom, called outlet needle. It also has long passageway from the brewer to the exit nozzle. If block-
age occurs in the exit nozzle, use unfolded paper clip to clean it out. To maintain proper operation
make sure the both needles and exit nozzle are kept clean.
Lower needle is not of tubular construction and does not go all the way through. It has U-shaped
configuration with slot on its side. This proprietary design makes clogging up this needle more difficult
compared to conventional design. If lower needle is blocked, wash cartridge under running water and
use unfolded paper clip to clean inside of the needle. It is not open all the way through. It has sealed
end.
Coffee runs out of the coffee capsule through the slot in the needle and then into the inside of the
coffee capsule using same slot. This way blockages are minimized and coffee runs out of the machine
at lower temperature. During the brew process water is very hot.
If upper, inlet nozzle get blocked use paper clip to clean. Needle has 3 openings around the central
spike. Check if the silicone seal on the upper piercing needle is properly installed.
Dispense few cups of water to rinse well. Clean with unfolded paper clip well. To dispense water
only you will need to open and close lid in order to send signal via sensor to control board. Never leave
blocked needle for more then 5 minutes, since blocked coffee will dry up and make it more difficult to
remove.
Be careful not to enter paper clip too deep in to passageway. IT is not straight and
food grade silicone tube can be damaged.
Call service center 1-844-452-2425 for an assistance. Pneumatic pump will be
shipped to you for cleaning the blockage.
Use paper ceip to clean dispensing
nozzle as shown
23