How To Adjust Water Temperature For High Altitude To Avoid Boiling; How To Adjust Water Filling Amount; How To Cancel Blow Off To Dry Cups - Glacial 8LCH-KK-SC-SSF-40 User Manual

HOW TO ADJUST WATER TEMPERATURE FOR HIGH ALTITUDE TO AVOID BOILING

In order to extract most of flavor from your Single Serve Cup your Brewer works at 201
good for elevations under 3500 feet.
- Immediately after power cord is plugged into the electrical outlet, you will hear an audible signal.
- At the same time , touch buttons "PREHEAT/READY" and "START" for 1 second, to enter into
SET mode. You will see all three (3) cup sizes' LED icons flashing.
- For altitude under 2800 Feet, you should touch button for "Small cup" for 1 second, until "Small
cup" LED will flash. Then touch START button to SET.
- For altitude under 5000 Feet , you should touch "Middle Cup" button for 1 second, until "Middle
cup" LED will flash. Then touch START button to SET.
- For altitude under 7000 Feet elevation, you should touch "Big cup" button for 1 second, until "Big
cup" LED will flash, then touch START button to SET.

HOW TO ADJUST WATER FILLING AMOUNT

- Immediately after power cord is plugged into the electrical outlet, you will hear an audible signal.
- At the same time , touch together buttons for "Middle Cup" and "START" for 1 second, water will
start dispensing from the Brewer. When water reaches required level desired for middle cup
setting touch "START" button to stop dispensing. Setting for middle cup is completed. Output
settings for "Small Cup" and "Big Cup" will be adjusted accordingly.

HOW TO CANCEL BLOW OFF TO DRY CUPS

(Suitable in case of open bottom cups or weakly glued lids. )
- Immediately after power cord is plugged into the electrical outlet, you will hear an audible signal.
- At the same time, touch together buttons for "PREHEAT/READY" and "Small Cup" for 1 second,
to enter into SET mode. My Cup light starts flashing.
- Touch "START" button to cancel Blow Off function. LED light for coffee pod picture will turn OFF.
NOTE: This model has memory chip to retain your settings. To return to factory settings
unplug the power cord and plug back again after 3 seconds, Hold "PRE-HEAT" and
"unlock" at the same time.
IMPORTANT NOTE:
simultaneously If you want to set the addtional setting when unit is already
plugged in.
Please touch "Small cup + Middle cup + Big cup"
17
F. It is
0