Glacial 8LCH-KK-SC-SSF-40 User Manual page 15

Dispense Cold Water
Note: After set up it will take up to 1 hour to form an ice bank. During this time compressor may run
continuously. This is normal.
1. Position bottle, glass, pitcher or cooking pot securely below cold water tap.
a. The right arrow below the cold water control indicates the location of
the cold water tap.
b. The target holes in the grill help to align water stream. This unit
dispenses water at a fast rate. To avoid splashes, hold cup as close to
the tap as possible.
2. Depress right control downward to start flow.
3. Release control once desired fill level is achieved.
Dispense Hot Water
CAUTION
This unit dispenses hot water at temperature that can severe burns. Avoid direct contact
with hot water. Keep small children and pets away from unit while dispensing. Never allow
small children to dispense hot water without proper and direct supervision.
Note: After setup, hot water will be available in 15-20 minutes.
1. Position suitabe cup securely below hot water tap.
a. The left arrow below the hot water control indicates the location of the hot water tap.
b. The target holes in the grill help to align water stream. This unit dispenses water at a fast rate.
To avoid splashes, hold cup as close to the tap as possible.
2. Push hot water release button (red) inward and depress control downward to start flow.
3. Release control once desired fill level is achieved.
4. For dispensing coffee see instructions for "how to brew coffee".
Replace an Empty Bottle
Notice: When your bottle is empty the water cooler will beep intermittently.
You may also hear a sucking sound when the bottle empties. This is normal and is another way to
be alerted that your bottle is empty.
Replace empty bottle as soon as you notice it is empty. If unavailable, leave door ajar or unplug
cooler to stop beeping noise and flashing lights.
There may be a small amount of water left in the bottle. This is normal.
1. Open door and slide bottle out.
2. Remove probe from bottle:
• Pull probe straight up until completely out of bottle.
• Hang probe on the door to prevent contamination.
3. Install fresh bottle:
• Place fresh bottle in front of bottle compartment.
• Clean fresh bottle with a soft cloth and warm soapy water or bleach solution then wipe with clean
wet cloth.
• Remove entire plastic cap from top of bottle.
• Insert probe into bottle.
• Push down on probe until it is seated.
• Slide bottle onto bottle compartment.
• Gently close the door.
HOT WATER
15