Glacial 8LCH-KK-SC-SSF-40 User Manual page 19

No hot water. Preheat LED light just blinks, cold is fine, no hot.
Reason:
- Possibly high limit thermal fuse had blown.
Correction:
- Check if Hot Water Switch at the back is in ON position. Check if bottle has water.
If problem persist call service center at 1-844-452-2425 and report the problem.
If required, replacement unit will be shipped to you. Please drain water as per manual and pack
cooler into original packing material and call service center to arrange pick up of returned unit.
No Hot Water:
After the weekend or long absence water level in the hot tank might be lower slow due to evaporation.
Just hold Hot Water dispensing button longer until cold water fills the hot hot tank and allow hot water to
flow.
Problems:
-Water flow slowed down.
- Hot water faucet started leaking.
- Does not stop dispensing coffee.
Reason:
Minerals build up in hot tank and water ways. small mineral particle blocked faucets, sole-
noid valves and flow meter.
Correction:
- Descale as described on page 13. Use distilled water, avoid mineral water if mineral w
ater used descale evey 6 months for average family usage. Descale every 3 months for office usage.
Water cooler does not operate
• Make sure the power cord is properly connected to a dedicated working outlet.
• Make sure energy savings switches are turned on. Make sure the cooler is plugged in and the circuit
breaker is not tripped. If needed, use another receptacle and confirm there is electricity going to the
cooler.
• Please test carefully.
No water is coming from the taps
• Check the hose connections from the water pump to the probe in the bottle, they must be well
connected to avoid air leaks.
• Check the hose connections from water pump to the dispensing probe.
• Check if leak valve is wet and has shut off water supply.
19