Operation - Glacial 8LCH-KK-SC-SSF-40 User Manual

OPERATION

CAUTION
CAUTION
This water cooler part of combination unit is intended for water cooling only, Do NOT use other
liquids. Do NOT use for other purposes. Warranty is void if used for any other liquids including
coffee, tea, juices, beer or wine. Using other liquids can be dangerous to your health.
This water cooler has been designed to fit standard water bottles with a 3, 5 or 5.2 gallon
capacity. Do NOT use alternative bottles. Avoid using disposable bottles, since they lack
rigidity.
Initial Set Up
Do NOT plug in until instructed to do so below.
1. Allow unit to sit upright for 4 hours.
2. This model uses a pump to pull water from the bottle to the reservoirs.
a. Please do the following:
• Open door and place fresh bottle in front of tray.
• Clean bottle cap and neck. Use soft cloth soaked in bleach solation.
• Remove entire plastic cap from bottle.
• Push down on probe head until it is seated.
• Push bottle inside of compartment.
• Close the door gently.
NOTICE: When using a 5 gallon rectangular bottle, slide into place as shown in illustration below.
3. Plug cord into a properly wired and grounded dedicated wall outlet.
a. Water will be pumped into the hot and cold water reservoirs from the bottle.
4. Turn ON hot and cold water power switches at the back of the unit.
Notice:
• At initial start-up it will take about 3 minutes for the reservoirs to fill.
• Door must be closed to operate water pump.
• If the lights continue to flash, your bottle may be empty. If problems persist, Call 1-844-452-2425 for
assistance.
14
Stainless Steel
tube for Self - Clean
function
Expandable telescopic
tube for drawing water
from the bottle