Install Software; Load Paper - Epson L200 Instructions

Before printing, attach the ink tank unit onto the printer. Don't lay the ink
tank unit down, or position the unit higher or lower than the product.
10
3

Load paper

1
2
3
Don't load paper sideways; always load it short edge first.
4
Do not connect the printer
to your computer or turn
on the printer until you are
instructed to do so.
Load paper with the
printable side faceup.
4

Install software

If your computer does not have a CD/DVD drive, you can download
the printer software from Epson's support site.
1
If the Auto Play window appears, click on Run
Epsetup.exe. If the Add New Hardware screen
appears, click Cancel and disconnect the UBS
cable.
2
3
4
5
Ink charging takes approximately 20 minutes. Do not unplug or turn off the
printer until ink charging is complete. The power light stops flashing.
Do not cancel the installation program before the procedure is completed,
or you will have to run the program again.
6
When you're done, remove the CD. You are ready to copy, print, and scan.
See the instructions on the back of this sheet CD or on your on-screen
User's Guide.
Make sure the printer is NOT CONNECTED to
your computer.
Connect the USB cable and turn
on the printer when you see this
screen.
To use the product, you need to
enter the IDs that are printed on
each ink bottle, then click Next.