Installing Wifi Module - RGBlink VENUS X1PRO User Manual

6.3.3 Installing WIFI Module

1. Remove the 5 screws on the top cover, and move the top cover, as shown in the figure below:
2. Install the WIFI module as shown in the figure below: lock the WIFI module with 2 pieces of
2*5 flat head screws, then connect the antenna junctor and the connector with the WIFI
antenna cable.
3. Install the external WIFI antenna, as shown in the figure below:
VENUS X1PRO User Manual
Chapter 6: Appendix
Connect antenna
junctor and connector
2*5 flat head screw
69