Table of Contents
Advertisement
3. Load the program files
Double click the upgrade tools (support Windows system), and click the icon
the setting interface as follows. Select the COM port (same with step 2), and set baudrate as
115200, click "OK".
Click "Select Files" (Mark 2), and select the .bin file in "VENUS X1PRO_Firmware Firmware
PackageX1PRO package_100M V1.X".
The .bin file in VENUS X1PRO package_100M V1.X is a package, which includes 6 subprogram.
Click
(Mark 4) to select all program files, then click "Upgrade" (Mark 5) to start
upgrade.
After upgrading, it will display "Upgrade Successfully", and the progress bar shows "100%".
If select one of the program files, click the corresponding subprogram, and click "Upgrade"
behind it. Same as above, it will display "Upgrade Successfully", and the progress bar shows
"100%" after upgrading.
4. The upgrade progress is about 2~3 minutes.
5. Plug into the power cord after upgrading, and factory reset. Restart the device again and
ensure the new program can operate normally.
Note:
The device will prompt "Restart the device" after upgrading. When restart for the first time, it
VENUS X1PRO
Figure 4 Upgrade Tool Interface
Figure 5 Serial Setting
User Manual
Chapter 6: Appendix
, pop-up
59
Advertisement
Table of Contents
