Table of Contents
Advertisement
overview
Advice for the installer
The installation and first ignition of the boiler must be
performed by qualified personnel in compliance with
current national regulations regarding installation, and
in conformity with any requirements established by
local authorities and public health organisations.
After the boiler has been installed, the installer must
ensure that the end user receives the declaration of
conformity and the operating manual, and should
provide all necessary information as to how the boiler
and the safety devices should be handled.
This appliance is designed to produce hot water for domestic
use.
It should be connected to a heating system and a distribution
network for domestic hot water, both of which must be compatible
with its performance and power levels.
The use of the appliance for purposes other than those specified is
strictly forbidden. The manufacturer cannot be held responsible for
any damage caused by improper, incorrect and unreasonable use
of the appliance or by the failure to comply with the instructions
given in this manual.
Installation, maintenance and all other interventions must be
carried out in full conformity with the governing legal regulations
and the instructions provided by the manufacturer. Incorrect
installation can harm persons, animals and possessions; the
manufacturing company shall not be held responsible for any
damage caused as a result. The boiler is delivered in a carton. Once
you have removed all the packaging, make sure the appliance is
intact and that no parts are missing. If this is not the case, please
contact your supplier.
Keep all packaging material (clips, plastic bags, polystyrene foam, etc.)
out of reach of children as it may present a potential hazard.
In the event of a fault and/or malfunction, turn the appliance
off, turn off the gas cock and do not attempt to repair it yourself.
Contact a qualified professional instead.
Before any maintenance or repair work is performed on the boiler,
make sure you have disconnected it from the electricity supply
by switching the external bipolar switch to the "OFF" position and
removing the fuse.
All repairs, which should only be performed using original spare
parts, should be carried out by a qualified professional. Failure
to comply with the above instructions could compromise the
safety of the appliance and invalidate all liability on the part of
the manufacturer.
In the event of any maintenance or other structural work in
the immediate vicinity of the ducts or flue gas exhaust devices
and their accessories, switch the appliance off by switching the
external bipolar switch to the "OFF" position and shutting off
the gas control valve. When the work has been completed, ask a
qualified technician to check the efficiency of the ducting and the
devices.
Turn the boiler off and turn the external switch "OFF" to clean the
exterior parts of the appliance.
Clean using a cloth dampened with soapy water. Do not use
aggressive detergents, insecticides or toxic products. If the
appliance is used in full compliance with current legislation, it
will operate in a safe, environmentally-friendly and cost-efficient
manner.
If using kits or optional extras, make sure they are authentic.
4
Supplied By www.heating spares.co Tel. 0161 620 6677
CE labelling
The CE mark guarantees that the appliance conforms to the fol-
lowing directives:
- 90/396/CEE
relating to gas appliances
- 89/336/CEE
relating to electromagnetic compatibility
- 92/42/CEE
relating to energy efficiency
- 73/23/CEE
relating to electrical safety
Symbols used on the data plate
Key:
1.
Brand
.
Manufacturer
3.
Boiler model - code
4.
Serial number - certification number
5.
Destination country - gas category
6.
Gas setting
7.
Boiler type
8.
Electrical data
9.
Maximum domestic hot water pressure
10.
Maximum heating pressure
11.
NOx class
1.
Efficiency
13.
Max - min heat input
14.
Max - min heat output
15.
Max/min operating room temperature
16.
Max. central heating temperature
17.
Gases which may be used
MIN
MAX
Advertisement
Table of Contents
