Power Button Board - HP X2 210 G2 Maintenance And Service Manual

Power button board

Description
Power button board
Power button board cable
Before removing the power button board, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and
then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet.
3. Disconnect all external devices from the tablet.
4. Remove the back cover (see
5. Remove the LCD shield (see
6. Remove the battery (see
Remove the power button board:
1. Remove the Phillips PM2.0×2.0 screw (1) that secures that secures the power button board to the
display panel assembly.
2. Lift the top of the board upward (2), and then pull the board out from under the tab (3).
3. Turn the board over so you can access the connector underneath (4).
4. Disconnect the cable from the system board (5).
Back cover on page 22).
LCD shield on page 28).
Battery on page 29).
Spare part number
902369-001
902352-001
Tablet component replacement procedures 33