Dock Component Replacement Procedures; Bottom Cover - HP X2 210 G2 Maintenance And Service Manual

Dock component replacement procedures

There are as many as 32 screws that must be removed, replaced, and/or loosened when servicing the dock.
Make special note of each screw size and location during removal and replacement.

Bottom cover

Description
Bottom cover for use in HP x2 models with a hard drive:
Silver models
White models
Red models
Bottom cover for use in HP x2 and HP x2 210 G2 models without a hard drive:
Silver models
Bottom cover for use in HP x2 models without a hard drive:
White models
Red models
Remove the bottom cover:
1. Place the dock upside-down on a flat surface.
2. Remove the two screw covers (1) and two silver Phillips PM2.0×4.0 screws (2).
3. Remove the rubber strip from the bottom cover (3).
4. Remove the four black Phillips PM2.0×3.0 screws (4) from under the rubber strip.
5. Insert a thin, plastic tool between the bottom cover and the dock (5) and pry upward to separate the
bottom cover from the dock.
40 Chapter 5 Removal and replacement procedures
Spare part number
902348-001
902349-001
902350-001
902345-001
902346-001
902347-001